Skip to Content

Changes for page ANU Seismic Data Loggers

Last modified by robert on 2025/04/24 14:58
From version 43.1
edited by robert
on 2025/03/03 18:26
Change comment: There is no comment for this version
To version 44.1
edited by robert
on 2025/03/03 18:26
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -76,26 +76,17 @@
76 76  
77 77  This menu also displays the firmware version, battery, external, and solar voltages, and the temperature of the system.
78 78  
79 -==== Upon setup ====
79 +* Check all Initialisation Parameters are marked as successful.
80 +* Check that solar voltage is above 10 V, otherwise the station will not last long.
80 80  
81 -- Check all Initialisation Parameters are marked as successful.
82 -
83 -- Check that solar voltage is above 10 V, otherwise the station will not last long.
84 -
85 -
86 86  == Live Seismometer Data ==
87 87  
88 88  This screen displays real time seismometer data for all 3 axes of the seismometer. Initially, a plot of raw data from all 3 channels is shown. By pressing enter, a high pass filter can be applied showing a more useful plot of all channels. The up and down arrows can be used to change between a view of all channels, individual channels, and all channels on different X axes.
89 89  
90 -==== Upon setup ====
86 +* Check that all 3 channels are present and are producing a signal.
87 +* Stomp on the ground near where the sensor is installed to check that a signal is being picked up by all 3 channels.
88 +* Common representations of poor signals include channels sloping smoothly from high values to zero, or sharp corners in the plots.
91 91  
92 -- Check that all 3 channels are present and are producing a signal.
93 -
94 -- Stomp on the ground near where the sensor is installed to check that a signal is being picked up by all 3 channels.
95 -
96 -- Common representations of poor signals include channels sloping smoothly from high values to zero, or sharp corners in the plots.
97 -
98 -
99 99  == GPS Data ==
100 100  
101 101  This menu displays the status of the stations' GPS connection. The screen lists; UTC time, UTC date, latitude, longitude, altitude, number of satellite connections, and SNR.
... ... @@ -102,12 +102,10 @@
102 102  
103 103  * Check that the station is connected to satellites
104 104  
105 -
106 106  == SD Information ==
107 107  
108 108  The menu lists if the SD card has been initialised, as well as the capacity and space free on the memory card. See "Data card formatting" (above) to see how to format and initialise the inserted SD card.
109 109  
110 -
111 111  == System Configuration ==
112 112  
113 113  This menu is used to set the stations identifiers and parameters.
... ... @@ -164,7 +164,6 @@
164 164  
165 165  Words to describe the TSAWR would go here, if needed
166 166  
167 - 
168 168  
169 169  
170 170  = ANU LPR-200 (Gen 2, FW 2.6a/2.7a, 2013 - current) =